AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateTrusted Furnace Replacement for Pembroke Pines Homeowners
When a furnace starts short-cycling, blowing lukewarm air, or failing to heat at all, the honest question is whether a repair will hold or whether replacement is the smarter spend. In Pembroke Pines, where mild winters mean your furnace may run only a few dozen nights a year, that decision still matters: a failing unit can leave a family without heat on the one cold snap that actually tests it. Our technicians have up to 15 years of experience and service nine major brands, so we know when a furnace is worth saving and when it isn’t. We give straight answers on your system, not a pitch. Same-day service is available for urgent calls. Call (866) 237-6150 for a free estimate.
What Our Furnace Replacement Service Includes
A furnace replacement is more than swapping a box. It’s a full system changeout: removing the old unit, confirming the new one is correctly sized for your home, and making sure the whole heating cycle runs safely and efficiently. Here’s what the work covers when we take on a replacement in Pembroke Pines.
Full System Assessment Before Replacement
Before recommending a new furnace, we inspect the existing unit, the ductwork, and the thermostat to understand why it’s failing. We check whether the problem is the furnace itself or something feeding it, because replacing a unit when the real issue is elsewhere wastes money. This assessment determines whether replacement is the right call or a repair gets you more years.

Correct Sizing and Load Calculation
An oversized furnace heats too fast, cycles on and off, and wears out sooner; an undersized one runs constantly and never quite catches up. We size the replacement to your home’s actual heating load rather than matching whatever was there before, which is often wrong. Getting the size right is the single biggest factor in how long the new furnace lasts and how evenly it heats.

Removal and Safe Disposal of the Old Unit
We disconnect the old furnace, remove it safely, and haul it away. Gas connections and electrical components are handled carefully and by trained hands, because both carry real risk. You don’t have to schedule a separate disposal or worry about the old unit sitting in a garage.

Installation and Connection
The new furnace is set, connected to the gas line and electrical supply, and tied into the existing ductwork and venting. We check clearances, confirm the flue and combustion air are correct, and verify the thermostat talks to the new unit. Every connection gets tested before we call the job done.
Commissioning and Airflow Check
After installation we run the system and measure airflow and temperature rise to confirm it’s performing to spec. We walk you through the new thermostat and controls so you know how to run the system. If anything reads off, we correct it before we leave.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Brands We Service for Furnace Replacement
We’re certified to work on nine major HVAC brands: Carrier, Trane, Lennox, Goodman, Rheem, York, Daikin, Bryant, and American Standard. That breadth matters when you’re replacing a furnace, because the right recommendation depends on your home, not on what a company happens to push. We know where Trane equipment wears and how its components age, and we know the failure points that show up in Lennox furnaces over time. The same goes for Goodman and Rheem systems, which are common in this part of South Florida and have their own quirks.
Because we service all nine manufacturers, we have no financial reason to steer you toward one brand over another. If a Goodman is right for your budget and load, that’s what we’ll recommend; if a Trane makes more sense for the long haul, we’ll say so. Whether you have a Trane, a Lennox, a Goodman, a Rheem, or any other make, we can help.
Signs You Need Furnace Replacement Right Now
- It’s over 15 years old and needs frequent repairs. Once a furnace starts needing multiple repairs a season, the math tips toward replacement. Each fix buys less time, and the money adds up faster than a new unit would have cost.
- You smell gas or notice unusual odors. A faint gas smell or a strange metallic or burning odor near the furnace is a safety concern, not a nuisance. Turn the system off and call us; gas and combustion problems need a trained technician, not a DIY fix.
- Heating bills climb without explanation. A furnace that’s losing efficiency works harder to do the same job. Rising bills with no change in how you use the system usually point to a unit nearing the end.
- The house won’t heat evenly or the air feels lukewarm. When some rooms stay cold no matter what the thermostat says, the furnace may be undersized or failing to distribute heat. This is worth diagnosing before it gets worse.
- Strange noises: banging, rattling, or screeching. New noises from the furnace signal mechanical trouble. Some are repairable; others mean internal components are failing. A technician can tell which.
Our Furnace Replacement Process – Step by Step
- 1
Diagnostic visit. We inspect the furnace, ductwork, and thermostat, and test the unit to confirm what’s failing. We check combustion, airflow, and electrical connections so the diagnosis is based on what we measure, not a guess.
- 2
Honest recommendation. We lay out whether repair or replacement serves you better, with the reasoning behind it. You get a clear picture of cost and lifespan, not pressure to buy.
- 3
Written estimate and sizing. If replacement is the call, we calculate the right size for your home and give you a written estimate. The price is set here, and the estimate sets the final price.
- 4
Scheduled installation. We order the equipment and set an install date. Replacement is planned work, not same-day, because it’s sized, ordered, and scheduled to go in right.
- 5
Install, test, and walkthrough. We remove the old unit, install the new one, verify airflow and temperature rise, and show you how to run the controls before we wrap up.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Furnace Replacement Cost in Pembroke Pines?
Furnace replacement in Pembroke Pines isn’t a single flat number; it depends on the size of your home, the furnace you choose, and whether any ductwork or venting needs attention. A straightforward changeout for a typical single-story home is on the lower end, while a larger home or a job that includes ductwork adjustments runs higher. For reference, a furnace repair in Pembroke Pines typically runs $150 – $700, and when that repair no longer makes economic sense, replacement becomes the smarter spend. A full changeout is a bigger investment, and we give you the number in writing before any work starts.
What affects the price: the equipment brand and model, the size of the furnace, the condition of your ductwork, and whether any venting or gas-line work is needed. To avoid overpaying, get an in-person assessment rather than a phone quote, and ask for the written estimate up front. Our free estimate includes the diagnostic check, sizing, and a clear explanation of what’s included, so you can compare fairly.
Furnace Replacement Near Pembroke Pines – Our Service Area
We serve homeowners across Pembroke Pines and the surrounding communities, including Watergate, Southwest Ranches, Cooper City, Country Club, Palm Springs North, Weston, Plantation, Broadview Park, and Pembroke Park. For urgent furnace issues, same-day service is available, and our fast dispatch from 7am to 7pm gets a technician to you quickly. You can also learn more about Remington AC Repair and the full range of heating and cooling work we take on.
Serving Pembroke Pines, FL – Our Local Coverage Area
We serve Pembroke Pines and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Furnace Replacement in Pembroke Pines
Furnace replacement is the full removal of your existing furnace and installation of a new one, including sizing, connection to gas and electrical, and testing. It’s different from a repair, which fixes a specific part of the existing unit. We recommend it when a furnace is too old, too inefficient, or failing in ways a repair can’t fix. If you’re unsure which you need, we’ll diagnose it during a visit.
Most residential furnace replacements are completed in a single day once the equipment is on hand. The work includes removal, installation, and testing, and the timeline depends on the size of the system and whether any ductwork or venting adjustments are needed. We give you a clear schedule when we book the install.
The cost depends on your home’s size, the furnace you choose, and the condition of your ductwork. A furnace repair runs $150 – $700, and when repair stops making sense, replacement is priced per job by a written estimate. The free estimate sets the final price, so there’s no guesswork. Call (866) 237-6150 for an exact quote; estimates are free.
Yes. We’re certified to work on Trane and Lennox equipment, along with Carrier, Goodman, Rheem, York, Daikin, Bryant, and American Standard. We know where each of these brands tends to wear and how their components age. Whether you have a Trane, a Lennox, or any other make, we can help.
Same-day service is available for urgent furnace problems. We answer 24/7 for the phone line, with fast dispatch from 7am to 7pm, Sunday through Friday. We’re closed Saturday, and a call outside dispatch hours is booked into the next opening. Call (866) 237-6150.
Warranty terms vary by manufacturer and model, and we’ll go over the specific coverage on the equipment you choose before you commit. We don’t make blanket warranty promises; we tell you what the manufacturer covers and what our installation covers. That way you know exactly what you’re getting.
Clear the area around the furnace and make sure we can access the unit and the gas shutoff. Remove anything stored nearby and keep pets and children out of the work area during installation. We’ll handle the rest, including protecting your floors and walking you through the new system when we’re done.
Schedule Your Furnace Replacement Service in Pembroke Pines Today
If your furnace is on its last legs, don’t wait for it to fail on the coldest night of the year. We give straight answers on whether repair or replacement is the right call, backed by up to 15 years of technician experience and certified knowledge of nine major brands. Call (866) 237-6150 for a free, no-obligation estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Remington AC Repair.