AC repair
Furnace & heating
Heat pumps
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateWhy Pembroke Pines Homeowners Choose Lennox HVAC
We provide independent Lennox HVAC service in Pembroke Pines, covering AC repair, AC replacement, heat pump repair and gas furnace work on Merit, Elite and Signature Collection equipment. What sets our Lennox work apart is that we diagnose to the actual control platform, fault history and charge specs that Lennox equipment uses, not a generic checklist borrowed from another brand. We’re an independent provider with no affiliation, authorization or warranty relationship with Lennox, and we say that plainly up front. Our technicians have up to 15 years of experience. Call (866) 237-6150 for a free estimate.
Why Trust Remington AC Repair for Your Lennox HVAC?
Lennox equipment is not hard to work on once you know how it communicates. It’s hard to work on if you treat it like every other condenser in the neighborhood. Communicating systems, variable-capacity compressors and ECM blower modules expect a technician who can read fault history, verify low-voltage wiring and understand how the board stages the equipment. That’s the part that trips up a lot of shops.
We use quality parts that fit Lennox equipment. For communicating controls, control boards and any component tied to the equipment warranty, we go with OEM Lennox parts. For commodity items like run capacitors and contactors, a quality aftermarket part does the job without inflating the bill. This keeps the repair warranty-safe and honest at the same time.
Our technicians have up to 15 years of experience across the brands we cover, and they work on Lennox every week. Because we also service Carrier, Trane and six other major brands, nothing about our recommendation is tied to what we happen to carry. We work on your system, not just the brands we sell. Free estimates, and the written estimate sets the final price.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Common Lennox HVAC Problems We Fix in Pembroke Pines
These are the Lennox failure patterns we see most in Pembroke Pines homes, and what’s usually behind them:
- iComfort and ComfortSense communication faults on Signature-series units. The system shows a communication error and stages oddly instead of simply quitting. Most of the time it’s a control board or thermostat wiring failure, not a dead compressor. A pro pulls the Lennox fault history and verifies the communicating wiring before replacing anything.
- Failed ECM blower modules and comfort control boards in Signature gas furnaces. These failures often present exactly like a bad blower motor. A technician who swaps the motor without checking the module ends up with a second failed part and a homeowner paying twice.
- Condensate and coil freeze issues in horizontal attic air handlers. In Pembroke Pines humidity, the float switch, drain pan and refrigerant charge are tightly linked. A coil that keeps freezing usually has a charge or airflow problem behind it, and a clogged drain line can flood an attic faster than a homeowner expects.
- Capacitor, contactor and condenser fan motor wear on Merit and Elite outdoor units. High summer temperatures and heavy run time wear these parts faster. A no-cool call often traces to a swollen run capacitor or pitted contactor, not refrigerant loss.
- Low-side refrigerant leaks at factory flare and braze joints. These show up as gradual cooling loss and rising run times. Locating the leak properly beats topping off refrigerant and waiting for the next call.
Here’s how a typical Lennox Service call usually goes. A Signature-series system with an iComfort thermostat often presents as a homeowner seeing a communication or system fault code with the outdoor unit staging erratically rather than dying outright. The usual culprit is a control-board or wiring and thermostat communication failure, and a qualified pro typically pulls the fault history, verifies the communicating wiring and board, and replaces the failed board or thermostat. On a Merit or Elite condenser, the more common call is a plain no-cool complaint traced to a swollen run capacitor or a pitted contactor. The pro checks pressures and amp draw, replaces the failed start component, and confirms charge before closing out. That’s the difference between a repair that lasts the season and one that comes back.
Lennox Parts & Our Repair-vs-Replace Approach
For communicating controls, control boards and warranty-sensitive components, OEM Lennox parts are the right call. For run capacitors and contactors, quality aftermarket parts do the same job for less. We choose based on what the part actually does, not on what’s easiest to mark up.
Repair versus replace comes down to math, not sales pressure. On an older Merit-series air conditioner with a leaking coil or a failed compressor, two major repairs in a short span usually cost more than a replacement, and we’ll say so directly. On a newer Elite or Signature system with a failed board, repair almost always makes sense. We lay out both paths and let you decide.
Pembroke Pines is mostly build-out, with housing stock from the 1970s through the 2000s. That means many original systems have already reached replacement age, and rooftops and attic closets in the 1980s and 90s subdivisions carry equipment that’s on its second or third major repair. When that’s the case, honest guidance is worth more than one more patch. Call (866) 237-6150 to talk through your Lennox system with a technician. Estimates are free.
Our Lennox Service Process – Step by Step
- 1
Diagnosis. We pull the Lennox fault history on communicating systems, check pressures, amp draw and thermostat wiring, and verify the control board before recommending any part. For a Signature furnace, the ECM module and comfort control board get checked before the motor is blamed.
- 2
Repair or install. On a repair, we replace only the failed component and confirm the fix fits the warranty. On a replacement, we discuss load, staged heating or a heat pump upgrade for a South Florida home where cooling load dominates, and confirm the equipment fits the ducting and the mechanical closet.
- 3
Test. After the repair, we run the system through a full cycle, verify charge on the low side, check amp draw on the compressor and blower, and confirm the thermostat is communicating cleanly before we leave.
- 4
Warranty. We explain what the parts warranty does and doesn’t cover, keep the receipt and part documentation with your paperwork, and make sure the fix doesn’t jeopardize coverage on the equipment you already own.
See the difference
Before
After
Before
After
Before
AfterLennox Products We Service & Install in Pembroke Pines
We service and install Lennox air conditioners, gas furnaces, heat pumps and ductless mini-split and multi-zone systems. On the cooling side that covers single-stage and variable-capacity equipment with communicating controls, and on the heating side it covers standard gas furnaces and heat pumps as well as the ECM blower platforms Signature-series furnaces use. In Pembroke Pines, most Lennox equipment we work on is paired with attic duct systems in single-family homes or stacked mechanical closets in townhomes, and we plan the job around whichever you have. We also install replacement systems when repair no longer makes sense. Call (866) 237-6150 for a free estimate.
We Also Service These Brands
We’re certified to work on nine major brands, including Carrier and Trane alongside Lennox. That matters if your home has a mixed setup or you’re deciding whether to replace a single brand with what fits your budget. A brand-agnostic shop has no reason to steer you toward one manufacturer, so the recommendation reflects your home, not what’s sitting in a warehouse.
FAQs – Lennox HVAC Service in Pembroke Pines
No. We’re an independent Lennox service provider with no affiliation, authorization or warranty relationship with Lennox. We repair, install and service Lennox equipment as a multi-brand shop, and we’re licensed and insured.
Yes. We use OEM Lennox parts for communicating controls, control boards and warranty-sensitive components, and quality aftermarket parts for commodity items like run capacitors and contactors. The written estimate sets the final price. Call (866) 237-6150 for a free estimate on your repair.
It’s usually one of the two, and the fault history tells us which. A pro pulls the Lennox fault log, verifies the communicating wiring between the thermostat and the board, and replaces only the failed component. Guessing wastes money. Call (866) 237-6150 and we’ll schedule a diagnosis.
No. A swollen run capacitor or pitted contactor on a Merit or Elite condenser is a small, straightforward repair, usually done the same visit. The technician checks pressures and amp draw afterward to confirm charge. Estimated cost for a Lennox diagnostic and repair runs $150 – $650. Call (866) 237-6150 for an exact quote – estimates are free.
On an older Merit unit, a leaking coil plus a second major failure usually tips the math toward replacement. A newer system with a failed board almost always justifies repair. We lay out both paths honestly and let you decide. Call (866) 237-6150 and we’ll talk through the numbers with you.
A failed ECM blower module or comfort control board often mimics a bad motor, and the furnace limits or cuts out because the board or module is at fault. A pro checks the module before swapping the motor. Estimates are free – call (866) 237-6150.
Yes, for a communicating thermostat we use an OEM Lennox part so the system’s communication and staging stay intact. Aftermarket thermostats can create the same fault code you started with. Call (866) 237-6150 for a free estimate.
We cover Lennox air conditioners, gas furnaces, heat pumps, and ductless mini-split and multi-zone systems, including communicating controls, ECM blower platforms and variable-capacity equipment. Call (866) 237-6150 with your model and we’ll confirm coverage.
No, proper service doesn’t void a Lennox warranty, but the parts used matter. Using OEM parts on warranty-sensitive components and keeping repair records protects you. We go over what your equipment warranty covers before we start. Call (866) 237-6150 for a free estimate.
Typical estimated pricing in Pembroke Pines:
| Service | Typical estimated range |
|---|---|
| AC Repair (Lennox diagnostic and repair) | $150 – $650 |
| AC Installation (Lennox system) | $3,500 – $7,500 |
| Tune-Up (Lennox cooling/heating) | $80 – $200 |
| Furnace Repair (Lennox gas furnace) | $150 – $700 |
These are estimates, and the written estimate sets the final price. Call (866) 237-6150 for an exact quote – estimates are free.
Most Lennox diagnostics and repairs, including a capacitor or contactor swap, finish the same visit. Communicating-control faults and coil or leak work can take longer because the fault history and charge verification take time. Call (866) 237-6150 for a free estimate.
Book Your Lennox Service in Pembroke Pines, FL
Whether your Lennox system is throwing an iComfort fault or your Merit condenser has stopped cooling, we can help. We repair, install and service Lennox equipment across Pembroke Pines as an independent provider with no affiliation with Lennox. Call (866) 237-6150. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Estimates are free.
Written by the team at Remington AC Repair.